Cut away the bead cover on both sides for a complete outer cord and inner cord section, allowing two inches from where the cords come out. 3. Pull the staples on both sides, if a QD 4. Split the inner cords at turn on' staples and layback all cords so... Tire Repairing and Vulcanizing - Pàgina 50per Henry Horace Tufford - 1918 - 98 pàginesVisualització completa - Sobre aquest llibre
| Henry H. Tufford - 1918 - 114 pàgines
...with first ply to fit from toe of bead up one inch on the cords, on the inside; second ply 1-2-inch above the toe of bead, I 1-2-inches on the cords on...This allows for the pulling the cords through and also.for. replacing. 6. Select and fit new outer cords. 7. Buff and cement. BUILDING UP OUTER CORD... | |
| Henry Clemens Pearson - 1922 - 1372 pàgines
...all cords laid back to the staples ; the outer cords are split at turn on staples and pulled ; the outer cords are taken out after the side wall has been cut off or buffed enough to clear the cords and the bead cover has been fully removed, thus allowing the cords to be... | |
| |